Cantilever and Pallet Rack in Trenton, GA

Trailer rails, extrusions and long sheet stock need cantilever rack. Arms extend from a single column line, so nothing blocks the load face.

Arm spacing comes from the shortest piece you store; arm capacity comes from the heaviest. We size both before drawing the run.

Palletized steel parts, axles and hardware get heavy fast. High-capacity selective pallet rack with heavier beams and steel decking handles them.

Distribution space off I-59 Exit 11 serves trucks heading toward Birmingham and Chattanooga. Fast turns favor selective rack with every pallet reachable.

Small buildings also mean shared space: offices, a shop corner and storage under one roof. We keep rack runs away from walk paths and shop doors.

If you only need a few bays now, we draw the full building so later additions line up.

Buildings with 17 to 22 ft clear, including distribution space off I-59 Exit 11, usually take two to three beam levels. Smaller footprints mean every aisle counts.

We start with your truck's turning radius and set the narrowest aisle it handles safely. Then we fit as many rows as the building allows.

For small parts and cartons, shelving at shorter level spacing often beats pallet rack in these heights.

Trenton/Dade Business Park North sits on US-11 North, 1.9 miles from I-59, 9.8 miles from I-24 and 24.4 miles from I-75. Trenton-Dade Industrial Park Phase II is marketed for new industrial sites.

Moving into a new building in either park? Our warehouse relocation team brings your rack with you.

Send part lengths and weights, pallet loads and your building size and clear height. A phone call often fills the rest.

We draw cantilever runs, pallet rows and shelving on one CAD plan and quote every component.

Phased installs keep fabrication and shipping moving.

If you lease in one of the Dade County parks, we can plan from the shell drawings.

Every run is anchored to the floor and capacity-labeled at handover.

How do you size cantilever arms for trailer rails?

How many pallet levels fit at 18 ft clear?

Should small parts go on shelving or pallet rack?

Can you plan rack for a small mixed-use building?